This guide describes how to configure softphone features (SIP) for ProCall Enterprise in conjunction with an Avaya IP Office.

ProCall Enterprisefrom V 6.1
Avaya IP Office
Version 10.1/11

Notes on the estos test environment

The ProCall softphone functions (SIP) were tested in the estos test environment with the telephone system specified above. The tests were performed with a maximum of two lines per SIP end device. The information described here was used during the setup of the telephone system for the login/registration of the individual SIP lines to the UCServer.

Note on codecs and UDP connections

For the connection of SIP lines to the UCServer, the telephone system must support the G.711 a-law for the SIP protocol and should have this set as the preferred codec for all end devices.

Only UDP connections are supported.

Note on the use of call forwarding in the UCServer

If the Call Forwarding feature is used in the UCServer, the SIP lines must allow second calls in order to use the Call Forwarding on Busy feature.

Avaya IP Office telephone system configuration

Set up as a SIP extension

The SIP line for ProCall users must be set up as a SIP extension.

Menu – Configuration – Extension – SIP Extension – VoIP

A third-party IP endpoint license must be reserved for the SIP extension under Reserve license

SIP line registration

For the registration of the SIP line, the following must be entered for the user

  • under Supervisor Settings: the login code

    Login code

    Please note that the login code MUST comply with the guidelines set in the TC system, otherwise the SIP line will be de-registered after some time.

  • under SIP: a SIP name

    SIP name

    It is strongly recommended to enter the extension of the base (which is assigned to the SIP extension) as the SIP name, otherwise, the phone number must be assigned manually to each SIP line in the UCServer.

UCServer configuration

The connection to the PBX is entered under Settings in the UCServer Administration as SIP Softphone connection under Telephony – Lines.

  1. Add telephone system  
    Select the Avaya IP Office.
  2. Enter the connection to the telephone system under Softphone Registrations as "SIP Softphone".

  3. After setting up the connection, all SIP lines must be added under Softphone Registrations.
    For the connection to an Avaya IP Office, the following must be specified:

    SIP name equal to extension
    as username"SIP Username"
    as password"Login code"
    SIP name not equal to extension
    as username"SIP extension"
    as password"Login code"
    as Auth. username"SIP name"

From ProCall 6.1, please note the following settings

On the SIP connection line group it is possible to define what the UCServer signals to the PBX when:

  • the client is not logged in or call protection is enabled
  • the call is rejected at the client or no devices are available

The required settings depend on the telephone system and its configuration.

Example: The telephone system should redirect incoming calls to the mailbox if the ProCall client is not logged in.

Problem: The PBX does not evaluate the busy here (486) sent by default from the UCServer and the calls are not redirected.

Possible solution: In the PBX, this setting is set up for Subscriber Unavailable, and Temporarily Unavailable (480) is selected for signaling on the UCServer.

Version note

Since estos has no influence on the further development of the supported telephone systems by the manufacturer, we cannot guarantee that the instructions described above will also be fully valid for future releases.